Chaise Mattress 101

I have quite a few of you wanting to know how I made my Chaise mattress (below), so I thought I would explain in one go. It’s simple…
We had a single bed foam mattress laying around and taking up room, the cover of this was ripped too…so, I stripped it, laid it on top of the Chaise and with a bread knife, started following the sides of the Chaise. You can pre mark it with a pen, then cut if you like. Once it is cut, you can tidy up the edges with your knife.
Then I laid a piece of black and white ticking (I think it was 2 meters) over the top of the mattress and under. Then slip stitch the ticking together. Then fold the ends over like a present, with the ends meeting the sides for a professional look. Slip stitch these down at both ends.
For the old style look. I just pinched about an inch of the foam the whole way around the top while I stitched every inch or so…no measuring here! Once that is done, I stood back and thought about how many ‘dents’ in the middle of the mattress I wanted (which was 4) and with 3 pieces of white embroidery thread, sewed through the middle of the mattress (make sure you have band aids on hand!), back up right next to it and tie off at the top. This works better I found if you kneel on the mattress while you are tying to get that pulled in look.
That’s pretty much it! Hope it makes sense. I don’t know what the technical terms are =)
happy sewing,
Ness xx

Comments

comments

Comments (7)

Leave a Reply to Lynette Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Verified by ExactMetrics